Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
user_manual:pre_processing [2022/07/01 08:30] Ali Baba |
user_manual:pre_processing [2023/01/28 13:22] Ali Baba [Creation of the geometry] |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| **We advise you to split the geometry creation in 2 steps**: | **We advise you to split the geometry creation in 2 steps**: | ||
| * First you should build the full geometry of the part that you would like to design. | * First you should build the full geometry of the part that you would like to design. | ||
| - | * And then, from this complete geometry, you should build a simplified geometry more suitable | + | * And then, from this complete geometry, you should build a simplified geometry more suited |
| Even though Salome proposes some geometry simplification tools, from our point of view, these tools are not as efficient as the FreeCad ones. | Even though Salome proposes some geometry simplification tools, from our point of view, these tools are not as efficient as the FreeCad ones. | ||